Extron electronic Computer Hardware AAP TX RX User Manual

USB Extenders • Setup Guide  
This guide provides basic instructions for an experienced technician to install and operate  
the Extron USB Extenders.  
The USB Extender Series includes the USB Extender Tx/Rx, AAP Tx/Rx, and Decora® Tx/Rx. They are USB transmitter and  
receiver pairs that extend the usable distance of USB 1.0, 1.1, and 2.0 standards with data transfer rates up to 480 Mbp and  
data transmission up to 450 ft (135 m) with standard Category 5/5e/6/6e/7 cable.  
The rack mountable Tx/Rx, AAP mountable Tx/Rx, and Decora Tx/Rx models can be mixed.  
Mount the USB Extenders  
The USB Extender series includes transmitters and receivers in three form factors to provide a variety of mounting options  
including:  
z
z
z
USB Extender Tx/Rx in quarter rack width, 3 inch deep, 1 inch high metal enclosures  
USB Extender AAP Tx/Rx for double-space Architectural Adapter Plate openings  
USB Extender D (Decora) Tx/Rx for one-gang wall box or mud ring mounting  
Choose the appropriate mounting location and install the USB Extender transmitter and receiver following instructions  
supplied with the mounting kit. If the rear panel connectors will be covered after mounting, make all connections prior to  
permanently mounting a USB Extender.  
UTP or STP CAT5 or better cable:  
Terminate both ends identically, in accordance with  
either the TIA/EIA T 568A or the TIA/EIA T 568B  
wiring standard.  
Laptop  
Keyboard  
USB  
USB  
Transmitter  
Receiver  
HUB  
HOST  
POWER  
12V  
POWER  
12V  
0.4A MAX.  
1.0A MAX.  
1
3
4
DO NOT  
CONNECT  
TO LAN  
DO NOT  
2
CONNECT  
TO LAN  
LINK  
LINK  
If the USB host is capable of supplying power,  
a transmitter power supply is not required.  
Four USB 2.0 compatible type A female  
connectors provide +5 VDC at up to  
500 mA to connected USB peripherals.  
The receiver must have a power supply connected.  
Ground  
+12 VDC  
Ground  
+12 VDC  
External  
External  
Power Supply  
(12 VDC, 1 A )  
Power Supply  
(12 VDC, 1 A )  
Run All Cables  
Connect the transmitter and receiver as shown above.  
NOTE: The host and hub connectors of the AAP and Decora models are on the front panel. The host  
connection on the AAP and Decora transmitter is a female mini USB Type B. Connection and operation  
are the same as the rack mount Tx/Rx models.  
1
 

Ecom Instruments Switch ECOM EF24F2G User Manual
Fostex DVR D 25 User Manual
FujiFilm Digital Camera Z1000EXR User Manual
Fujitsu Server RX200 S2 User Manual
Fujitsu Tablet Accessory FTP 628WSL 110 User Manual
Furuno Marine RADAR FAR 2117 User Manual
GE Air Conditioner AZ75E12DAC User Manual
GE Clothes Dryer DCVH660GH User Manual
GE Washer S2000 User Manual
Gigabyte Network Router GN A16B User Manual