Indoor DWDR 3-Axis Varifocal
700TVL IR Dome Camera
Operation Instructions
Model No. ED640
Please read this manual first for correct installation and operation. This manual should be
retained for future reference. The information in this manual was current when published.
The manufacturer reserves the right to revise and improve its products. All specifications are
therefore subject to change without notice.
PRECAUTIONS
1. Do not install the camera near electric or magnetic fields.
Install the camera away from TV/radio transmitters, magnets, electric motors, transformers and
audio speakers since the electromagnetic fields generated from these devices may distort the
video image or otherwise interfere with camera operation.
2. Never disassemble the camera beyond the recommendations in this manual nor introduce
materials other than those recommended herein. Improper disassembly or introduction of
corrosive materials may result in equipment failure or other damage.
3. Try to avoid facing the camera toward the sun.
In some circumstances, direct sunlight may cause permanent damage to the sensor and/or
internal circuits, as well as creating unbalanced illumination beyond the capability of the camera
to compensate.
4. Keep the power cord away from water and other liquids and never touch the power cord
with wet hands. Touching a wet power cord with your hands or touching the power cord with
wet hands may result in electric shock.
5. Never install the camera in areas exposed to oil, gas or solvents.
Oil, gas or solvents may result in equipment failure, electric shock or, in extreme cases, fire.
6. Cleaning
For cameras with interchangeable lenses, do not touch the surface of the sensor directly with the
hands. Use lens tissue or a cotton tipped applicator and ethanol to clean the sensor and the
camera lens. Use a damp soft cloth to remove any dirt from the camera body. Please do not use
complex solvents, corrosive or abrasive agents for cleaning of any part of the camera.
7. Do not operate the camera beyond the specified temperature, humidity or power source
ratings. This camera is suitable for indoor operation only. Use the camera at temperatures within
-10° ~ +50° (14 ~122 ) and humidity between 30% and 90%. The input power source is
12VDC. Regulated power supply required.
Specifications
TV System
NTSC
1/3” Sony Super HAD II Color CCD
768Hx494V
Image Sensor
Effective Pixels
Resolution
700 TV Lines
Lens
2.8~12mm VF AI
Scanning System
Scanning Frequency
Auto Shutter Speed
Sync. System
S/N Raito
525Lines, 2:1Interlace
15.734KHz(H),59.94Hz
1/60 to 1/100,000sec.
Internal
More than 52dB (AGC off)
5 Button Navigation. Multiple options
OSD
English, Spanish, French, Portuguese,
German, Polish, Japanese, Chinese
Auto/Color Black & White;
OSD Language
Day & Night
Digital Day/Night with programmable switch levels and delays
Min. Illumination
IR LEDs
0.01 lux nominal; 0 lux with IR LEDs on
24 smart LEDs, 850nm
IR Range
82 feet (depends on scene IR reflectivity)
Off/On with programmable area of interest and gain
Off, Low, Middle, High
Smart IR Control
Auto Gain Control
DWDR
Off/On with adjustable weight
Off/On for two areas with programmable
area of interest and gain
BLC
BLC/HLC
HLC
Off/Night Only/Always with adjustable level
0.45; Display compensation option for CRT or LCD with
adjustable levels
Gamma Correction
DNR
2D DNR Off/On
Lens Shading
Compensation
Off/On, adjustable for level and image center
Mirror
Off/On
Off/On
Negative Image
White Balance
Digital Pixel Correction
AWB ( 2,100˚k ~ 9,100˚k)
Manual operation; programmable threshold and area
3
Motion Detection
Privacy Zones
Video Output
On screen indication; up to 4 programmable areas
Up to 8areas programmable for location and color
NTSC CVBS, 1Vp-p, 75Ω
DC 12V 10%
Power Supply
Power Consumption
Operating Temperature
Storage Temperature
Operating Humidity
Dimension
160mA Nominal / 320mA IR ON
14ºF ~ 122ºF ; -10°C~50°C
-4ºF ~ 140ºF ; -20°C~60°C
to 90% RH max.
4.41”/112mm diameter, 3.43”/87mm high
7.2oz/205g
Weight
Certifications
CE/FCC
Dimensions
Mounting holes
1.77” radius
3 places
4
Installation
Warning: To prevent electrical shock, turn off the electrical power before making electrical
connections. OBSERVE POLARITY when connecting 12VDC power to the camera.
1. Select mounting location. Open cover using tool provided.
2. Place template and drill holes (5/8” minimum for wires, ~¼” for hollow wall anchors; ~3/32” pilot
hole for screws alone). Insert wall anchors if used.
3. Mount camera to ceiling with 3 screws and adjust camera direction.
4. Replace dome cover on base (snaps on).
1
2.
3.
4.
OSD Menu Controls and Video Test Point
Press the Menu/Enter button to bring up the OSD
menu. Navigate the menu with the direction keys.
Select RETURN to move back to the previous level
menu. When exiting the main menu, choose SAVE,
NOT SAVE or RESET (factory defaults) as desired.
Use adapter cable supplied to connect test monitor to
video test point.
Lens Adjustment
Use fingers or screwdriver to adjust field of view (zoom)
and focus.
5
Menu Setting (Default values shown in parentheses).
(Rev. 1.1)
MENU
SUB MENU AND FACTORY SETTING PARAMETERS
BRIGHTNESS
IRIS SPEED
0 ~ 255
0 ~ 15
(50)
(5)
DC
LENS
(DC)
MANUAL
SHUTTER
BRIGHTNESS
0 ~ 255
(50)
AUTO, 1/60(50), FLK, 1/250, 1/500, 1/1000, 1/2000,
1/4000, 1/5000, 1/10000, 1/100000
(1/60)
(MIDDLE)
(32)
EXPOSURE
AGC
OFF, LOW, MIDDLE, HIGH
DWDR (OFF) LEVEL
ATW1
0 ~63
ATW2
AWCꢀSET
ANTI.CRL
WHITE BAL
(ATW1)
COLOR TEMP
MANUAL, INDOOR, OUTDOOR
MANUAL
(OFF)
BLUE (MANUAL) 0 ~ 255
(65)
(26)
RED (MANUAL)
0 ~ 255
AREA SEL.
AREA STATE
GAIN
AREA1, AREA2
ON, OFF
0 ~ 255
0 ~ 10
(128)
(005)
(005)
(005)
(005)
(177)
BLC
HLC
HEIGHT
BACKLIGHT
(OFF)
WIDTH
0 ~ 10
LEFT/RIGHT
TOP/BOTTOM
D=>N LEVEL
0 ~ 15
0 ~ 15
0 ~ 255
NIGHT ONLY, ALL DAY
ONLY)
(NIGHT
MODE
MASK SKIP
OFF, ON
160~255
1 ~ 30
0 ~ 64
0 ~ 30
(OFF)
D=>N LEVEL
D--ꢀN DELAY
N=> D LEVEL
N--ꢀD DELAY
(192)
(1) SEC
(032)
AUTO
(5) SEC
COLOR
BURST
ON,OFF
ON, OFF
IR GAIN
HEIGHT
WIDTH
(OFF)
(ON)
0 ~ 255
0 ~ 015
0 ~ 015
DAYNIGHT
(AUTO)
(122)
(006)
(010)
B/W
IR SMART
LEFT/RIGHT
0 ~ 015
(002)
TOP/DOWN
HIGH, LOW
0 ~ 015
(007)
IR LEVEL
(HIGH)
6
MENU
SUB MENU AND DEFAULT SETTING
D=>N DELAY
N=>D DELAY
0 ~ 30
0 ~ 30
(1)
(1)
DAYNIGHT
(AUTO)
EXT
START
(Cover the lens then press enter key) ꢁ Process now
DPC VIEW
LS VALUE
DIFF.
OFF, ON
0 ~ 63
(OFF)
(015)
(010)
(021)
(255)
(008)
(118)
(ON)
0 ~ 63
DPC
AREA HS
AREA HE
AREA VS
AREA VE
CAM TITLE
0 ~ 255
0 ~ 255
0 ~ 255
0 ~ 255
OFF, ON
AREA
1~4
(AREA1)
AREA STATE
HEIGHT
WIDTH
LEFT/RIGHT
TOP/BOTTOM
DEGREE
VIEW
ON,OFF
0~15
0~15
0~15
0~15
0~255
ON,OFF
1~8
(OFF)
(4)
(4)
(3)
(2)
(32)
(ON)
(1)
MOTION
(OFF)
SPECIAL
AREA
PRIVACY
(OFF)
AREA STATE
ON,OFF
(ON)
HEIGHT
0 ~ 125
0 ~ 215
0 ~ 220
0 ~ 105
0~15
(032)
(032)
(032)
(016)
(014)
WIDTH
PRIVACY
LEFT/RIGHT
TOP/BOTTOM
COLOR
SPECIAL
LEVEL
0~255
(157)
(074)
(053)
H-CENTER
V-CENTER
ON, OFF
ON, OFF
FONT
0~255
0~255
LENS SHAD. (OFF)
IMAGE ADJ.
2DNR
(ON)
(OFF)
MIRROR
0 ~ 15 (003)
0 ~ 15 (003)
(137)
FONT COLOR
ID & TITLE
0 ~ 255
0 ~ 31
CONTRAST
SHARPNESS
(016)
7
MENU
SUB MENU AND DEFAULT SETTING
PED LEVEL
0~63
(028)
0~255
(192)
0.3~1.0
(0.55)
0~63
(028)
0~255
(192)
0.3~1.0
(0.45)
0~63
(028)
0~255
(176)
CRT
COLOR
GAIN
GAMMA
DISPLAY
PED LEVEL
LCD
COLOR
GAIN
GAMMA
PED LEVEL
USER
DISPLAY
IMAGE ADJ.
COLOR
GAIN
SPECIAL
NEG.IMAGE
ON, OFF
(OFF)
LANGUAGE
(ENGLISH)
ENGLISH,CHINESE1, ESPANOL, POLISH, DEUTSCH,
PORTU FRANCAIS,JAPANESE
VERSION
00 00 00
EXIT
SAVE, NOT SAVE, RESET
*Depending on setting of sub menu, the default value may be changed.
8
EverFocus Electronics Corp.
Corporate Headquarters:
12F, No.79 Sec. 1 Shin-Tai Wu Road,
Hsi-Chih, Taipei, Taiwan
TEL: +886-2-26982334
FAX: +886-2-26982380
China Office:
Room 609, Technology Trade Building,
Shangdi Information Industry Base,
Haidian District, Beijing, China 100085
TEL: +86-10-62973336~39
FAX: +86-10-62971423
U.S.A - California Office:
1801 Highland Avenue Units A & B
Duarte, CA 91010
TEL: +1-626-844-8888
FAX: +1-626-844-8838
U.S.A - New York Office:
415 Oser Avenue Unit S
Happauge, NY 11788
TEL: +1-631-436-5070
FAX: +1-631-436-5027
Europe - Germany Office:
Albert-Einstein-Strasse 1,
D-46446 Emmerich, Germany
TEL: +49-2822-93940
FAX: +49-2822-939495
Japan Office:
5F Kinshicho city Building,
2-13-4 Koto-Bashi,
Sumida-Ku, Tokyo, 130-0022 Japan
TEL: +81-3-5625-8188
FAX: +81-3-5625-8189
India Office:
UK Office:
Unit 12 Spitfire Business Park
Hawker Road
Croydon, CR0 4WD
London: 0845 430 9999
Telford: 0845 430 8888
Fax: 020 8649 9907
Suite 803, Housefin Bhavan, C-21,
Bandra Kurla Complex, Bandra (East),
Mumbai 400051. India.
TEL: +91-222-444-8791
FAX: +91-222-444-8790
Your EverFocus product is designed and
manufactured with high quality materials and
components which can be recycled and reused.
This symbol means that electrical and
electronic equipment, at their end-of-life,
should be disposed of separately from your
household waste.
Please, dispose of this equipment at your local
community waste collection/recycling centre.
In the European Union there are separate
collection systems for used electrical and
electronic product.
Please, help us to conserve the environment
we live in!
Ihr EverFocus Produkt wurde entwickelt und
hergestellt
mit
qualitativ
hochwertigen
Materialien und Komponenten, die recycelt und
wieder verwendet werden können.
Dieses Symbol bedeutet, dass elektrische und
elektronische
Geräte
am
Ende
ihrer
Nutzungsdauer vom Hausmüll getrennt entsorgt
werden sollen.
Bitte entsorgen Sie dieses Gerät
bei Ihrer örtlichen kommunalen
Sammelstelle oder im Recycling
9
|