CONVERTIBLE
HAND/STAND MIXER
OWNER’S MANUAL
Model EP585W/EP585WR/ EP585WL
127V., 60Hz., 325 Watts
EURO-PRO Operating LLC
Boston, MA, 02465
1 (800) 798-7398
COPYRIGHT© EURO-PRO OPERATING LLC 2008
Read all the sections of this booklet and follow all the instructions carefully.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
3. While the hand mixer is still in the
Assembling the Hand Mixer to
the Stand
raised position, insert either the
beaters or the dough hooks.
4. To lower the hand mixer, press and
hold the tilt button with one hand
while holding the hand mixer with the
other hand and slowly lower the hand
mixer down. (Fig. 6)
Warning: To avoid injury when
inserting or removing beaters or
dough hooks, always set the speed
selector on “0” and unplug the appliance.
1. Before using your Convertible
Hand/Stand Mixer for the first time,
wash the beaters, dough hooks,
bowls and spatula in warm, sudsy
water. Rinse and dry thoroughly. Use
a damp cloth to wash over the mixer
base and the hand mixer. Dry with a
soft cloth. NEVER immerse the base
stand or the hand mixer in water or
any other liquids.
Attaching the Dough Hooks to
the Hand Mixer
Warning: To avoid injury when
assembling the hand mixer to the
stand, always set the speed selector on
“0” and unplug the appliance.
1. Ensure that the hand mixer is not
plugged in to an electrical outlet
and that the speed control switch
is on the “0” (off) position.
1. Press the tilt button, located on the
top of the support pivot . While the
button is depressed, ease the support
2. The dough hooks have a set
method of fitting into the hand
mixer because they are not
Press the
tilt button
and tilt the
hand
mixer
down
pivot back. (Fig. 4)
Tilt Button
identical. One has a grommet and
the other does not. (Fig. 2)
Support
Pivot
2. Before assembling your Convertible
Hand/Stand Mixer, make sure that the
power cord is unplugged from the
electrical outlet and that both the
speed control and the base speed
control dial are in the “OFF” position.
Grommet
Fig. 6
Fig. 4
Fig. 2
The support pivot will lock into this
raised position until it is released by
pressing the tilt button again.
5. To remove the hand mixer from the
pivot support, first raise the mixer by
pressing the tilt button and raise the
mixer up. (Fig. 7) the mixer will lock
into the raised position.
6. Then press the mixer release button
which is located on the under side of
the pivot support with one hand and
with the other lift the hand mixer by
the handle upwards and away from
the support pivot. (Fig. 8)
3. Looking at the under side of the
hand mixer, you will see that one
of the sockets has a red dot over
it. (Fig. 3) Insert the dough hook
with the grommet into this socket.
Attaching the Beaters to the
Hand Mixer
1. Ensure that the hand mixer is not
plugged in to an electrical outlet
and that the speed control switch
is on the “0” (off) position.
2. Insert the beaters into the sockets
on the under side of the hand
mixer and twist counter clockwise
until the beater is firmly fitted into
the socket.
3. To release the beaters from the
unit, press on the beater eject
button on the front of the unit and
they will pop out. (Fig. 1)
2. To connect the hand mixer to the
support pivot, locate the two retaining
prongs on the support pivot into the
two rectangular holes in the heel of
the hand mixer. (Fig. 5) When the
hand mixer is seated on the support
pivot, press down on the hand mixer
to click it into place and lock the hand
mixer and the support pivot together.
Grommet
Press the
tilt button
and tilt the
hand
mixer up
Rectangular
holes
Fig. 3
Press
eject
button
4. Then insert the other dough hook
into the other socket. Push both
dough hooks in until you hear a
click confirming that they are
securely in place.
Fig. 7
Retaining
prongs
Support
pivot
Fig. 5
5. To release the dough hooks from
the unit, press on the beater eject
button on the front of the unit and
they will pop out. (Fig. 1)
Note: Ensure that the beaters or
dough hooks are fully inserted into
the correct sockets or your mixing
results may be affected.
Note: Ensure that the two retaining
prongs on the support pivot are fully
connected into the hand mixer.
Hand
mixer
release
button
Fig. 1
Fig. 8
3
4
OPERATING INSTRUCTIONS
CARE & CLEANING
Warning: Before cleaning your
Fitting the Bowl onto the
Turntable of the Stand
Using the Convertible Hand/Stand
Mixer
Storing Your Hand/Stand Mixer
Hand/Stand Mixer, ensure that the
power is turned off and that the power
cord is not plugged into the electrical
outlet. Always switch off and unplug
before cleaning.
You can keep your Hand/Stand Mixer in
a convenient place on your kitchen
counter ready for use. Place the beaters
and dough hooks into the bowl. Storing
the beaters or dough hooks in a drawer
with other kitchen utensils may cause
damage.
Warning: To avoid injury when
assembling the hand mixer to the
stand, always set the speed selector on
“0” and unplug the appliance.
Warning: To avoid injury when
assembling the hand mixer to the
stand, always set the speed selector on
“0” and unplug the appliance.
1. Wipe the outside area of the
Hand/Stand Mixer with a damp cloth
and polish with a soft, dry cloth. NEVER
immerse the hand mixer, stand, plug or
power cord into water or any other
liquid.
1. Place the base of the mixing bowl
onto the turntable of the stand. To
fully lock the mixing bowl in place,
press down and turn the mixing bowl
in a clockwise direction until you hear
it click into place. (Fig. 9)
1. Before plugging the hand/stand mixer
into the electrical outlet, assemble the
unit with the desired accessories.
2. Set the speed selector switch to the
“HI” or “LO” position.
Never wind the power cord around the
motor after use as the warmth of the
motor may cause damage to the power
cord.
2. Wipe any excess food particles from
the power cord.
3. Select the speed that you desire.
3. To make cleaning easier, remove
beaters/dough hooks and wash right
away after use. Wash the mixing
bowl, beaters and dough hooks in
warm, soapy water. The stainless
steel mixing bowl, beaters and dough
hooks are dishwasher safe. The plastic
bowl, bowl lid and spatula are top rack
dishwasher safe ONLY. Do NOT use
scouring pads, harsh detergents or
abrasive cleaners to clean the bowls,
beaters or dough hooks. Dry with a soft,
clean cloth.
MIXING GUIDE
MIXING
TASK
RECOMMENDED
SPEED(S)
Folding &
Blending
“LO” 1 & 2
“LO” 3 & 4
Fig. 9
Light Mixing
Creaming &
Beating
“HI” 6 - 8 or “LO” 5
2. To remove the mixing bowl from the
stand, press down and turn the mixing
bowl counter clockwise. The mixing
bowl can now be detached from the
turntable and lifted away. (Fig. 10)
Whipping &
Aerating
“HI” 9 & 10 or
BURST
IMPORTANT INSTRUCTIONS
4. Select the bowl speed – “LO” or “HI”
depending on how fast you want the
bowl to turn. Use the “LO” bowl
speed for mixing speed 1-5. Use the
“HI” bowl speed for mixing speed
6-10. If you do not wish the bowl to
turn, leave the bowl speed in the
“OFF” position.
ALWAYS
NEVER
ALWAYS make sure that your hands are dry
before handling the plug or switching on the
appliance.
NEVER place your hand in the bowl while it is in
operation.
ALWAYS use the mixer on a dry, level surface.
NEVER use this appliance outdoors.
ALWAYS unplug unit from the electrical outlet
when not in use or when removing attachments
and before cleaning.
NEVER use this appliance for other than for
intended use. This appliance is for household use
only.
Note:
Fig. 10
•
Always select the speed setting
before the mixing bowl speed to
prevent ingredients from being flicked
out of the mixing bowl.
Always start mixing at slow speeds
and increase the speed gradually to
prevent the ingredients splashing out
of the bowl.
NEVER mix dry, thick or heavy mixture for more
than 60 seconds without turning off the hand
mixer and stirring the ingredients before
continuing.
ALWAYS remove the beaters or dough hooks
from the mixer before washing.
Note: It is easier to fit the mixing bowl to
the turntable when the hand mixer is not
attached to the pivot support.
•
ALWAYS avoid contact with moving parts while
unit is in operation. Keep hands, hair, clothing as
well as other utensils away from beaters/dough
hooks during operation.
NEVER use harsh, abrasive or caustic cleansers
to clean this appliance.
NEVER allow children to use this appliance
unsupervised.
NEVER leave this appliance unattended while in
use.
NEVER let the power cord to hang over the edge
of a table or counter, touch hot surface or
become knotted.
NEVER eject attachments with the unit operating.
5
6
EP585W
EP585WR
EP585WL
ONE (1) YEAR LIMITED WARRANTY
EURO-PRO OPERATING LLC warrants this product to be free from defects in
material and workmanship for a period of one (1) year from the date of purchase
when utilized for normal household use.
If your appliance fails to operate properly while in use under normal household
conditions within the warranty period, return the complete appliance and
accessories, freight prepaid. For Customer Service support, call 1 (800) 798-
If the appliance is found to be defective in material or workmanship, EURO-
PRO Operating LLC will repair or replace it free of charge. Proof of purchase
date and $12.95 to cover the cost of return shipping and handling must be
included.*
The liability of EURO-PRO Operating LLC is limited solely to the cost of the
repair or replacement of the unit at our option. This warranty does not cover
normal wear of parts and does not apply to any unit that has been tampered with
or used for commercial purposes. This limited warranty does not cover damage
caused by misuse, abuse, negligent handling or damage due to faulty packaging
or mishandling in transit.
This warranty is extended to the original purchaser of the unit and excludes all
other legal and/or conventional warranties. The responsibility of EURO-PRO
Operating LLC if any, is limited to the specific obligations expressly assumed by
it under the terms of the limited warranty. In no event is EURO-PRO Operating
LLC liable for incidental or consequential damages of any nature whatsoever.
Some states do not permit the exclusion or limitation of incidental or
consequential damages, so the above may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights
which vary from state to state.
*Important: Carefully pack item to avoid damage in shipping. Be sure to
include proof of purchase date and to attach tag to item before packing
with your name, complete address and phone number with a note giving
purchase information, model number and what you believe is the problem
with item. We recommend you insure the package (as damage in shipping
is not covered by your warranty). Mark the outside of your package
“ATTENTION CUSTOMER SERVICE”. We are constantly striving to
improve our products, therefore the specifications contained herein are
subject to change without notice.
Printed in China
7
|