Extron electronic Extron 60 1043 12 XTP Transmitter 60 1043 12 User Manual

Product Category  
XTP T HDMI and XTP R HDMI • Setup Guide  
This guide provides instructions for an experienced installer to install and connect the Extron XTP T HDMI transmitter and XTP R HDMI receiver.  
c
a b  
d
e f g  
Transmitter Connections  
Receiver Connections  
a DC power connector  
h DC power connector  
SIG  
LINK  
INPUTS  
POWER  
12V  
AUDIO  
ON  
OVER XTP  
AUDIO  
L
R
1.0  
A
MAX  
RS-232  
IR  
RESET  
b HDMI input connector  
i XTP input connector  
OFF  
HDMI  
LOOP-THRU  
+
+
Tx Rx  
G
Tx Rx  
XTP OUT  
LAN  
c HDMI Loop-thru connector j LAN connector  
d Analog audio input connector k RS-232/IR Over XTP connector  
XTP T HDMI Rear Panel  
e RS-232/IR Over XTP  
l HDMI output connector  
m Analog audio output connector  
n S/PDIF audio output connector  
o Relay connectors  
h
k
i j  
l m n o  
connector  
f XTP output connector  
g LAN connector  
OUTPUTS  
RELAYS  
SIG  
LINK  
POWER  
12V  
OVER XTP  
AUDIO  
AUDIO  
ON  
1
2
L
R
RS-232  
IR  
1.0  
A
MAX  
RESET  
OFF  
Tx Rx  
G
Tx Rx  
+
-
+
-
HDMI  
LAN  
S/PDIF  
XTP IN  
Installation  
XTP R HDMI Rear Panel  
Step 1 Mounting  
Turn off or disconnect all equipment power sources and mount the transmitter and receiver as required.  
Step 2 Connecting inputs  
a. Connect a digital video source to the female HDMI connector of the XTP T HDMI (see babove). It can accept HDMI, DVI (with an  
appropriate adapter), or DisplayPort video signals.  
NOTES:  
Use an Extron LockIt® Locking Bracket to secure HDMI cables to the connectors.  
Video input from a DisplayPort source must be a dual mode DisplayPort source.  
b. Connect a digital video display to the HDMI loop-thru connector on the transmitter to locally display the input source. Displays that are not  
HDCP compliant display a green screen when HDCP encrypted content is sent to them (see cabove).  
c. Connect balanced or unbalanced stereo audio to the  
Tip  
Tip  
Sleeve  
Tip  
Ring  
Sleeves  
Tip  
3.5 mm, 5-pole captive screw connector (see dabove).  
Sleeve  
Ring  
Step 3 — Connecting Throughput Devices  
Do not tin the wires!  
a. Connect a twisted pair cable between the XTP connectors on  
Balanced Stereo Input  
Unbalanced Stereo Input  
the transmitter and receiver (see fand iabove).  
Pins:  
12345678  
ATTENTION:  
network.  
Do not connect these connectors to a computer data or telecommunications  
TIA/EIA T 568 B  
Pin Wire Color  
The XTP T HDMI and XTP R HDMI are compatible with CAT 5e, 6, 6a, and 7 shielded twisted pair  
(F/UTP, SF/UTP, and S/FTP) and unshielded twisted pair (U/UTP) cable. Extron recommends using  
the following practices to achieve full transmission distances up to 330 feet (100 m) and reduce  
transmission errors.  
1
2
3
4
5
6
7
8
White-orange  
Orange  
White-green  
Blue  
z
Use Extron XTP DTP 24 SF/UTP cable for the best performance. If not using XTP DTP 24  
cable, at a minimum, Extron recommends 23 AWG, solid conductor, STP cable with a minimum  
bandwidth of 400 MHz.  
White-blue  
Green  
z
z
Terminate cables with shielded connectors to the TIA/EIA T 568 B standard.  
White-brown  
Brown  
Limit the use of more than two pass-through points, which may include patch points, punch  
down connectors, couplers, and power injectors. If these pass-through points are required, use  
CAT 6 or 6a shielded couplers and punch down connectors.  
Insert Twisted  
Pair Wires  
NOTE: When using CAT 5e or CAT 6 cable in bundles or conduits, consider the following:  
Do not exceed 40% fill capacity in conduits.  
Do not comb the cable for the first 20 m, where cables are straightened, aligned, and secured in tight bundles.  
Loosely place cables and limit the use of tie wraps or hook and loop fasteners.  
Separate twisted pair cables from AC power cables.  
Signal LED Lights on the transmitter when it is transmitting a video signal or a test pattern. Lights on the receiver when it receives an  
active XTP input signal from the transmitter.  
Link LED Lights yellow when a valid link between an XTP input and output is established.  
1

Motorola V60i User Manual
Kenwood K CD01 User Manual
JVC SP MXK50 User Manual
Hitachi Travelstar HTS727575A9E364 User Manual
Gevalia Programmable 12 Cup Coffeemaker XCC 12 User Manual
FLAVIA Beverage Systems Flavia Coffeemaker User Manual
Denon DCD CX3 User Manual
Cuisinart DGB 500C User Manual
Centon electronic DSP32GB 001 User Manual
Airlink101 AWLL5099 User Manual